EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

S51ZK-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object S51ZK-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1761301036	37 Count	213 Count	35 Count
1761297432	23 Count	140 Count	22 Count
1761293829	9 Count	70 Count	9 Count
1761290226	155 Count	1052 Count	139 Count
1761286623	144 Count	981 Count	129 Count
1761283020	134 Count	837 Count	120 Count
1761279434	127 Count	757 Count	114 Count
1761275831	119 Count	698 Count	107 Count
1761272228	110 Count	642 Count	99 Count
1761268625	99 Count	556 Count	89 Count
1761265022	90 Count	502 Count	81 Count
1761261418	79 Count	453 Count	71 Count
1761257834	70 Count	402 Count	63 Count
1761254231	61 Count	332 Count	55 Count
1761250628	55 Count	277 Count	50 Count
1761247024	48 Count	231 Count	44 Count
1761243421	39 Count	187 Count	36 Count
1761239818	31 Count	145 Count	29 Count
1761236234	23 Count	101 Count	22 Count
1761232631	11 Count	49 Count	11 Count
1761229027	143 Count	1076 Count	128 Count
1761225424	133 Count	981 Count	119 Count
1761221821	124 Count	904 Count	111 Count
1761218218	113 Count	842 Count	101 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)