EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SR2DTW-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2DTW-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1777805207	837 Count	839 Count	494 Count
1777803526	834 Count	837 Count	492 Count
1777801845	831 Count	830 Count	490 Count
1777800165	828 Count	828 Count	488 Count
1777798484	825 Count	825 Count	486 Count
1777796803	822 Count	823 Count	484 Count
1777795122	820 Count	821 Count	483 Count
1777793691	814 Count	819 Count	482 Count
1777792010	811 Count	816 Count	480 Count
1777790329	808 Count	814 Count	478 Count
1777788648	805 Count	801 Count	476 Count
1777786968	802 Count	798 Count	474 Count
1777785287	800 Count	792 Count	473 Count
1777783606	797 Count	789 Count	471 Count
1777781925	794 Count	786 Count	469 Count
1777780244	791 Count	783 Count	467 Count
1777778564	788 Count	780 Count	465 Count
1777776883	785 Count	777 Count	463 Count
1777775202	782 Count	774 Count	461 Count
1777773521	780 Count	772 Count	460 Count
1777772090	774 Count	764 Count	459 Count
1777770409	771 Count	756 Count	457 Count
1777768728	768 Count	754 Count	455 Count
1777767047	765 Count	751 Count	453 Count
1777765367	762 Count	748 Count	451 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)