EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SR2WH-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2WH-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1769955350	318 Count	838 Count	303 Count
1769953549	286 Count	755 Count	272 Count
1769951748	253 Count	661 Count	242 Count
1769949948	224 Count	576 Count	217 Count
1769948147	189 Count	482 Count	183 Count
1769946346	163 Count	414 Count	158 Count
1769944546	116 Count	320 Count	113 Count
1769942745	89 Count	222 Count	87 Count
1769940944	61 Count	156 Count	60 Count
1769939144	31 Count	87 Count	31 Count
1769937343	348 Count	1031 Count	331 Count
1769935542	320 Count	962 Count	304 Count
1769933742	294 Count	895 Count	279 Count
1769931941	267 Count	795 Count	253 Count
1769930140	235 Count	710 Count	222 Count
1769928370	203 Count	611 Count	195 Count
1769926569	173 Count	512 Count	166 Count
1769924768	144 Count	414 Count	138 Count
1769922968	114 Count	323 Count	109 Count
1769921167	87 Count	240 Count	85 Count
1769919366	58 Count	157 Count	57 Count
1769917566	28 Count	77 Count	28 Count
1769915765	387 Count	1039 Count	375 Count
1769913965	357 Count	959 Count	346 Count
1769912164	328 Count	876 Count	318 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)