EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP5UID-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP5UID-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1761289535	11 Count	362 Count
1761289118	18 Count	548 Count
1761287794	10 Count	319 Count
1761287317	17 Count	505 Count
1761286052	9 Count	276 Count
1761285515	16 Count	471 Count
1761284311	8 Count	254 Count
1761283714	15 Count	446 Count
1761282570	7 Count	227 Count
1761281913	14 Count	421 Count
1761280828	6 Count	200 Count
1761280111	13 Count	394 Count
1761279087	5 Count	170 Count
1761278310	12 Count	363 Count
1761277346	4 Count	143 Count
1761276509	11 Count	333 Count
1761275605	3 Count	111 Count
1761274707	10 Count	303 Count
1761273863	2 Count	83 Count
1761272905	9 Count	273 Count
1761272121	1 Count	50 Count
1761271104	8 Count	242 Count
1761270380	0 Count	23 Count
1761269302	7 Count	218 Count
1761268639	57 Count	1013 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)