EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

EA8EE-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA8EE-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1753250508	247 Count	186 Count	186 Count
1753248704	243 Count	183 Count	183 Count
1753246906	239 Count	180 Count	180 Count
1753245098	235 Count	177 Count	177 Count
1753243295	231 Count	174 Count	174 Count
1753241493	227 Count	171 Count	171 Count
1753239689	223 Count	168 Count	168 Count
1753237923	219 Count	165 Count	165 Count
1753236120	215 Count	162 Count	162 Count
1753234320	211 Count	159 Count	159 Count
1753232513	207 Count	156 Count	156 Count
1753230711	203 Count	153 Count	153 Count
1753228907	199 Count	150 Count	150 Count
1753227104	195 Count	147 Count	147 Count
1753225301	191 Count	144 Count	144 Count
1753223499	187 Count	141 Count	141 Count
1753221694	183 Count	138 Count	138 Count
1753219891	179 Count	135 Count	135 Count
1753218088	175 Count	132 Count	132 Count
1753216306	171 Count	129 Count	129 Count
1753214503	167 Count	126 Count	126 Count
1753212700	163 Count	123 Count	123 Count
1753210897	159 Count	120 Count	120 Count
1753209094	155 Count	117 Count	117 Count
1753207291	151 Count	114 Count	114 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)