EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP9LJE-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9LJE-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1761125258	474 Count	824 Count	438 Count
1761123457	464 Count	815 Count	429 Count
1761121657	453 Count	804 Count	419 Count
1761119856	440 Count	792 Count	407 Count
1761118056	430 Count	782 Count	398 Count
1761116254	419 Count	770 Count	388 Count
1761114453	407 Count	754 Count	377 Count
1761112653	388 Count	727 Count	359 Count
1761110861	365 Count	698 Count	337 Count
1761109060	354 Count	676 Count	327 Count
1761107262	341 Count	650 Count	315 Count
1761105459	328 Count	622 Count	303 Count
1761103658	316 Count	597 Count	292 Count
1761101857	302 Count	548 Count	279 Count
1761100057	289 Count	520 Count	267 Count
1761098256	277 Count	493 Count	256 Count
1761096455	264 Count	465 Count	244 Count
1761094655	251 Count	440 Count	232 Count
1761092853	238 Count	411 Count	220 Count
1761091052	226 Count	383 Count	209 Count
1761089258	212 Count	355 Count	196 Count
1761087457	199 Count	321 Count	184 Count
1761085657	186 Count	296 Count	172 Count
1761083856	174 Count	273 Count	161 Count
1761082055	162 Count	257 Count	150 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)