EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP5UID-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP5UID-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1777802340	15 Count	326 Count
1777800539	10 Count	296 Count
1777798737	9 Count	267 Count
1777796941	8 Count	236 Count
1777795140	7 Count	210 Count
1777793338	6 Count	184 Count
1777791537	5 Count	159 Count
1777789741	3 Count	133 Count
1777787939	2 Count	104 Count
1777786138	1 Count	72 Count
1777784336	0 Count	49 Count
1777782540	30 Count	1014 Count
1777780739	29 Count	982 Count
1777778937	28 Count	948 Count
1777777136	27 Count	919 Count
1777775340	26 Count	886 Count
1777773539	25 Count	859 Count
1777771737	24 Count	825 Count
1777769936	23 Count	793 Count
1777768140	22 Count	761 Count
1777766338	21 Count	726 Count
1777764537	20 Count	693 Count
1777762736	19 Count	656 Count
1777760940	17 Count	615 Count
1777759138	16 Count	575 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)