EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP2UUU-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2UUU-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1777818800	348 Count	469 Count	348 Count
1777817000	346 Count	467 Count	346 Count
1777815200	341 Count	462 Count	341 Count
1777813400	339 Count	460 Count	339 Count
1777811599	336 Count	457 Count	336 Count
1777809799	332 Count	453 Count	332 Count
1777807999	329 Count	449 Count	329 Count
1777806199	326 Count	440 Count	326 Count
1777804398	322 Count	436 Count	322 Count
1777802598	320 Count	434 Count	320 Count
1777800800	317 Count	431 Count	317 Count
1777799000	315 Count	429 Count	315 Count
1777797200	313 Count	427 Count	313 Count
1777795400	309 Count	422 Count	309 Count
1777793600	308 Count	421 Count	308 Count
1777791799	305 Count	418 Count	305 Count
1777789999	303 Count	416 Count	303 Count
1777788200	303 Count	416 Count	303 Count
1777786398	302 Count	415 Count	302 Count
1777784598	286 Count	399 Count	286 Count
1777782798	276 Count	389 Count	276 Count
1777780998	274 Count	387 Count	274 Count
1777779199	272 Count	385 Count	272 Count
1777777399	270 Count	383 Count	270 Count
1777775598	267 Count	380 Count	267 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)