EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP9LJE-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9LJE-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1777474161	626 Count	640 Count	573 Count
1777472360	615 Count	630 Count	563 Count
1777470559	579 Count	595 Count	528 Count
1777468759	568 Count	585 Count	518 Count
1777466958	558 Count	576 Count	509 Count
1777465158	547 Count	566 Count	499 Count
1777463365	536 Count	556 Count	489 Count
1777461564	525 Count	546 Count	479 Count
1777459764	514 Count	536 Count	469 Count
1777457963	503 Count	526 Count	459 Count
1777456162	492 Count	516 Count	449 Count
1777454362	481 Count	506 Count	439 Count
1777452561	470 Count	496 Count	429 Count
1777450761	459 Count	486 Count	419 Count
1777448960	448 Count	476 Count	409 Count
1777447159	437 Count	466 Count	399 Count
1777445359	427 Count	457 Count	390 Count
1777443558	416 Count	447 Count	380 Count
1777441764	405 Count	437 Count	370 Count
1777439963	394 Count	427 Count	360 Count
1777438163	384 Count	418 Count	351 Count
1777436362	372 Count	407 Count	340 Count
1777434560	361 Count	397 Count	330 Count
1777432760	350 Count	387 Count	320 Count
1777430959	339 Count	377 Count	310 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)