EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ2ODE-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2ODE-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1765189614	301 Count	508 Count
1765187813	300 Count	507 Count
1765186013	299 Count	506 Count
1765184212	298 Count	503 Count
1765182412	297 Count	502 Count
1765180617	296 Count	501 Count
1765178817	295 Count	498 Count
1765177016	294 Count	497 Count
1765175216	293 Count	496 Count
1765173415	292 Count	495 Count
1765171614	291 Count	494 Count
1765169814	290 Count	494 Count
1765168013	289 Count	493 Count
1765166213	288 Count	492 Count
1765164412	287 Count	491 Count
1765162611	286 Count	490 Count
1765160811	285 Count	489 Count
1765159017	284 Count	488 Count
1765157216	283 Count	487 Count
1765155415	282 Count	486 Count
1765153615	281 Count	485 Count
1765151814	280 Count	484 Count
1765150013	279 Count	483 Count
1765148213	278 Count	482 Count
1765146412	277 Count	481 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)