EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

F6JON-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F6JON-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1777794067	879 Count	990 Count	797 Count
1777793461	867 Count	977 Count	786 Count
1777792857	857 Count	966 Count	777 Count
1777792254	847 Count	954 Count	768 Count
1777791651	836 Count	941 Count	758 Count
1777791046	826 Count	928 Count	749 Count
1777790443	814 Count	915 Count	738 Count
1777789839	804 Count	904 Count	729 Count
1777789236	793 Count	890 Count	719 Count
1777788632	781 Count	877 Count	708 Count
1777788029	770 Count	866 Count	698 Count
1777787547	762 Count	857 Count	691 Count
1777786944	753 Count	846 Count	683 Count
1777786341	743 Count	835 Count	674 Count
1777785737	734 Count	824 Count	666 Count
1777785134	724 Count	812 Count	657 Count
1777784531	714 Count	801 Count	648 Count
1777783927	706 Count	792 Count	641 Count
1777783323	696 Count	781 Count	632 Count
1777782719	686 Count	770 Count	623 Count
1777782116	674 Count	757 Count	612 Count
1777781513	664 Count	746 Count	603 Count
1777780909	653 Count	734 Count	593 Count
1777780306	642 Count	721 Count	583 Count
1777779703	629 Count	708 Count	571 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)