EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

EA4ATS-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA4ATS-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1769969827	5 Count	633 Count
1769968057	4 Count	515 Count
1769966253	3 Count	391 Count
1769964450	2 Count	291 Count
1769962647	1 Count	196 Count
1769960843	0 Count	91 Count
1769959040	12 Count	1058 Count
1769957237	11 Count	961 Count
1769955433	10 Count	865 Count
1769953630	9 Count	766 Count
1769951827	8 Count	644 Count
1769950055	7 Count	553 Count
1769948252	6 Count	480 Count
1769946448	5 Count	416 Count
1769944645	4 Count	345 Count
1769942842	3 Count	278 Count
1769941039	2 Count	211 Count
1769939235	1 Count	139 Count
1769937432	0 Count	73 Count
1769935629	17 Count	1004 Count
1769933825	16 Count	945 Count
1769932055	15 Count	895 Count
1769930251	14 Count	848 Count
1769928448	13 Count	783 Count
1769926644	12 Count	702 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)