EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ2CPA-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2CPA-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1773895060	49 Count	707 Count
1773893259	48 Count	695 Count
1773891458	47 Count	681 Count
1773889658	46 Count	669 Count
1773887857	45 Count	657 Count
1773886056	44 Count	644 Count
1773884262	43 Count	632 Count
1773882462	42 Count	619 Count
1773880661	41 Count	607 Count
1773878860	40 Count	595 Count
1773877059	39 Count	583 Count
1773875259	38 Count	571 Count
1773873458	37 Count	559 Count
1773871658	36 Count	529 Count
1773869857	35 Count	513 Count
1773868056	34 Count	496 Count
1773866255	33 Count	480 Count
1773864455	32 Count	464 Count
1773862661	31 Count	448 Count
1773860860	30 Count	431 Count
1773859060	29 Count	416 Count
1773857259	28 Count	400 Count
1773855459	27 Count	384 Count
1773853658	26 Count	368 Count
1773851857	25 Count	351 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)