EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

MB7USU-5 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object MB7USU-5. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1777774353	759 Count	618 Count	367 Count
1777772552	757 Count	616 Count	366 Count
1777770752	754 Count	613 Count	364 Count
1777768951	752 Count	611 Count	363 Count
1777767150	750 Count	609 Count	362 Count
1777765350	748 Count	607 Count	361 Count
1777763549	747 Count	606 Count	361 Count
1777761748	744 Count	603 Count	359 Count
1777759946	742 Count	602 Count	358 Count
1777758146	739 Count	599 Count	356 Count
1777756345	734 Count	595 Count	352 Count
1777754552	732 Count	593 Count	351 Count
1777752751	729 Count	590 Count	349 Count
1777750951	727 Count	588 Count	348 Count
1777749150	725 Count	586 Count	347 Count
1777747349	724 Count	585 Count	347 Count
1777745549	722 Count	583 Count	346 Count
1777743748	719 Count	580 Count	344 Count
1777741947	717 Count	578 Count	343 Count
1777740147	715 Count	576 Count	342 Count
1777738346	713 Count	574 Count	341 Count
1777736545	711 Count	572 Count	340 Count
1777734744	708 Count	569 Count	338 Count
1777732955	706 Count	567 Count	337 Count
1777731154	704 Count	565 Count	336 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)