EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

EB2BRA-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EB2BRA-15. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1777788911	31 Count	133 Count
1777787107	30 Count	129 Count
1777785344	29 Count	126 Count
1777783540	28 Count	119 Count
1777781737	27 Count	118 Count
1777779934	26 Count	115 Count
1777778130	25 Count	113 Count
1777776327	24 Count	110 Count
1777774523	23 Count	108 Count
1777772720	22 Count	104 Count
1777770917	21 Count	102 Count
1777769113	20 Count	99 Count
1777767310	19 Count	98 Count
1777765507	18 Count	95 Count
1777764341	17 Count	93 Count
1777762537	16 Count	90 Count
1777760733	15 Count	86 Count
1777758930	14 Count	85 Count
1777757127	13 Count	82 Count
1777755323	12 Count	80 Count
1777753520	11 Count	76 Count
1777751716	10 Count	74 Count
1777749913	9 Count	72 Count
1777748110	8 Count	71 Count
1777746306	7 Count	68 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)