EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

F4FWW-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F4FWW-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1773888305	232 Count	212 Count	113 Count
1773886504	230 Count	210 Count	112 Count
1773884703	228 Count	209 Count	111 Count
1773882902	226 Count	203 Count	110 Count
1773881102	224 Count	200 Count	109 Count
1773879301	222 Count	199 Count	108 Count
1773877500	220 Count	197 Count	107 Count
1773875700	218 Count	195 Count	106 Count
1773873904	216 Count	193 Count	105 Count
1773872104	214 Count	191 Count	104 Count
1773870303	212 Count	189 Count	103 Count
1773868502	210 Count	187 Count	102 Count
1773866702	208 Count	186 Count	101 Count
1773864901	206 Count	184 Count	100 Count
1773863100	204 Count	183 Count	99 Count
1773861300	202 Count	182 Count	98 Count
1773859499	201 Count	182 Count	98 Count
1773857698	200 Count	182 Count	98 Count
1773855898	198 Count	181 Count	97 Count
1773854097	196 Count	180 Count	96 Count
1773852304	194 Count	178 Count	95 Count
1773850504	192 Count	177 Count	94 Count
1773848703	190 Count	175 Count	93 Count
1773846902	188 Count	174 Count	92 Count
1773845102	186 Count	172 Count	91 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)