EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP2OSA-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2OSA-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1766031260	396 Count	298 Count	103 Count
1766030359	395 Count	297 Count	103 Count
1766029458	394 Count	296 Count	103 Count
1766028558	392 Count	294 Count	102 Count
1766027657	390 Count	292 Count	101 Count
1766026777	388 Count	290 Count	100 Count
1766025876	387 Count	290 Count	100 Count
1766024975	385 Count	288 Count	99 Count
1766024074	383 Count	285 Count	98 Count
1766023173	381 Count	281 Count	97 Count
1766022272	379 Count	279 Count	96 Count
1766021371	377 Count	277 Count	95 Count
1766020470	375 Count	275 Count	94 Count
1766019569	374 Count	273 Count	94 Count
1766018668	373 Count	272 Count	94 Count
1766017767	371 Count	269 Count	93 Count
1766016913	369 Count	266 Count	92 Count
1766015966	368 Count	265 Count	92 Count
1766015065	366 Count	264 Count	91 Count
1766014164	365 Count	263 Count	91 Count
1766013263	363 Count	261 Count	90 Count
1766012362	361 Count	258 Count	89 Count
1766011462	360 Count	257 Count	89 Count
1766010561	358 Count	256 Count	88 Count
1766009660	356 Count	253 Count	87 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)