EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

F5MIW-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F5MIW-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1773899596	363 Count	486 Count	323 Count
1773898692	355 Count	475 Count	316 Count
1773897788	345 Count	465 Count	307 Count
1773896884	337 Count	456 Count	300 Count
1773895980	327 Count	442 Count	292 Count
1773895075	318 Count	429 Count	285 Count
1773894171	308 Count	414 Count	276 Count
1773893267	299 Count	402 Count	268 Count
1773892362	288 Count	388 Count	258 Count
1773891458	278 Count	375 Count	249 Count
1773890552	267 Count	360 Count	240 Count
1773889647	256 Count	347 Count	230 Count
1773888854	245 Count	335 Count	220 Count
1773887950	236 Count	321 Count	212 Count
1773887046	222 Count	304 Count	199 Count
1773886142	213 Count	293 Count	191 Count
1773885237	200 Count	276 Count	180 Count
1773884333	191 Count	264 Count	172 Count
1773883429	179 Count	252 Count	161 Count
1773882525	168 Count	238 Count	152 Count
1773881615	154 Count	220 Count	139 Count
1773880711	143 Count	202 Count	129 Count
1773879806	132 Count	184 Count	119 Count
1773878902	122 Count	170 Count	110 Count
1773877998	110 Count	155 Count	99 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)