EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

EA4ATS-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA4ATS-12. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1777805216	15 Count	912 Count
1777803413	14 Count	853 Count
1777801609	13 Count	755 Count
1777799806	12 Count	691 Count
1777798002	11 Count	635 Count
1777796199	10 Count	569 Count
1777794396	9 Count	510 Count
1777792592	8 Count	464 Count
1777790789	7 Count	415 Count
1777788986	6 Count	356 Count
1777787183	5 Count	307 Count
1777785380	4 Count	252 Count
1777783615	3 Count	207 Count
1777781812	2 Count	165 Count
1777780008	1 Count	119 Count
1777778205	0 Count	58 Count
1777776401	17 Count	1016 Count
1777774598	16 Count	965 Count
1777772795	15 Count	912 Count
1777770992	14 Count	868 Count
1777769189	13 Count	820 Count
1777767386	12 Count	767 Count
1777765582	11 Count	720 Count
1777763779	10 Count	670 Count
1777762014	9 Count	621 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)