EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP2OSA Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2OSA. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1777815764	268 Count	405 Count	79 Count
1777813963	267 Count	403 Count	79 Count
1777810362	265 Count	400 Count	79 Count
1777804959	259 Count	388 Count	76 Count
1777803159	258 Count	386 Count	76 Count
1777795963	250 Count	378 Count	76 Count
1777786960	245 Count	368 Count	76 Count
1777785159	241 Count	355 Count	73 Count
1777783358	240 Count	350 Count	73 Count
1777779757	238 Count	346 Count	73 Count
1777776163	232 Count	341 Count	73 Count
1777774362	231 Count	338 Count	73 Count
1777770761	229 Count	333 Count	73 Count
1777768960	228 Count	330 Count	73 Count
1777767160	227 Count	328 Count	73 Count
1777765359	226 Count	326 Count	73 Count
1777763558	222 Count	320 Count	70 Count
1777754562	213 Count	310 Count	70 Count
1777745559	208 Count	302 Count	70 Count
1777740156	203 Count	296 Count	68 Count
1777736555	201 Count	295 Count	68 Count
1777734754	193 Count	283 Count	61 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)