EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

OK1LOL-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK1LOL-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1755804149	222 Count	896 Count
1755800543	220 Count	888 Count
1755793331	216 Count	869 Count
1755784353	211 Count	848 Count
1755780746	209 Count	843 Count
1755778943	208 Count	840 Count
1755777139	207 Count	838 Count
1755775336	206 Count	835 Count
1755773533	205 Count	832 Count
1755771730	204 Count	828 Count
1755768124	202 Count	823 Count
1755766357	201 Count	820 Count
1755762751	199 Count	800 Count
1755760948	198 Count	797 Count
1755757341	196 Count	792 Count
1755755538	195 Count	789 Count
1755751932	193 Count	782 Count
1755750129	192 Count	778 Count
1755744758	189 Count	770 Count
1755742955	188 Count	768 Count
1755739349	186 Count	761 Count
1755735743	181 Count	756 Count
1755733939	180 Count	753 Count
1755732136	179 Count	749 Count
1755730333	178 Count	747 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)