EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

MB7ULR Telemetry

This is the latest recevied telemetry packets stored in our database for station/object MB7ULR. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1769979130	912 Count	589 Count	390 Count
1769975529	910 Count	587 Count	389 Count
1769971929	907 Count	585 Count	387 Count
1769968328	904 Count	582 Count	385 Count
1769964727	901 Count	579 Count	383 Count
1769961126	898 Count	576 Count	381 Count
1769957525	895 Count	573 Count	379 Count
1769953924	892 Count	570 Count	377 Count
1769950323	889 Count	567 Count	375 Count
1769946722	886 Count	564 Count	373 Count
1769943122	883 Count	561 Count	371 Count
1769939521	880 Count	558 Count	369 Count
1769935920	877 Count	555 Count	367 Count
1769932319	874 Count	552 Count	365 Count
1769928718	871 Count	549 Count	363 Count
1769925117	868 Count	546 Count	361 Count
1769921516	865 Count	543 Count	359 Count
1769917916	862 Count	540 Count	357 Count
1769914315	859 Count	537 Count	355 Count
1769910714	856 Count	534 Count	353 Count
1769907113	853 Count	531 Count	351 Count
1769903512	851 Count	529 Count	350 Count
1769899911	848 Count	526 Count	348 Count
1769896310	845 Count	523 Count	346 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)