EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

OK0HCS-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK0HCS-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1777783147	38 Count	969 Count
1777781344	37 Count	942 Count
1777779541	36 Count	919 Count
1777777738	35 Count	889 Count
1777775935	34 Count	855 Count
1777774132	33 Count	820 Count
1777772329	32 Count	790 Count
1777770526	31 Count	763 Count
1777768723	30 Count	732 Count
1777766919	29 Count	695 Count
1777765156	28 Count	660 Count
1777763353	27 Count	624 Count
1777761550	25 Count	592 Count
1777759747	24 Count	568 Count
1777756140	22 Count	503 Count
1777754337	21 Count	473 Count
1777752533	20 Count	445 Count
1777750730	19 Count	422 Count
1777748926	18 Count	394 Count
1777747123	17 Count	372 Count
1777745320	16 Count	345 Count
1777743552	15 Count	311 Count
1777741749	14 Count	289 Count
1777739946	12 Count	269 Count
1777738143	11 Count	251 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)