EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ9SIM-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9SIM-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1753121570	899 Count	584 Count	101 Count
1753117985	897 Count	584 Count	101 Count
1753114384	895 Count	584 Count	101 Count
1753110782	893 Count	584 Count	101 Count
1753107181	891 Count	584 Count	101 Count
1753103579	889 Count	584 Count	101 Count
1753099978	887 Count	583 Count	101 Count
1753096377	885 Count	583 Count	101 Count
1753092775	883 Count	580 Count	101 Count
1753089173	881 Count	580 Count	101 Count
1753085572	879 Count	580 Count	101 Count
1753081970	877 Count	579 Count	101 Count
1753078369	875 Count	579 Count	101 Count
1753074785	871 Count	577 Count	99 Count
1753071184	863 Count	571 Count	93 Count
1753067582	861 Count	570 Count	93 Count
1753063981	859 Count	570 Count	93 Count
1753060380	857 Count	570 Count	93 Count
1753056778	855 Count	570 Count	93 Count
1753053177	853 Count	570 Count	93 Count
1753049575	851 Count	570 Count	93 Count
1753045974	849 Count	570 Count	93 Count
1753042372	847 Count	570 Count	93 Count
1753038771	845 Count	570 Count	93 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)