EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ5STR-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ5STR-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1753186968	26 Count	278 Count
1753186067	25 Count	272 Count
1753185167	24 Count	251 Count
1753184266	23 Count	239 Count
1753183365	22 Count	235 Count
1753182464	21 Count	229 Count
1753181563	20 Count	225 Count
1753180663	19 Count	219 Count
1753179762	18 Count	213 Count
1753178861	17 Count	206 Count
1753177960	16 Count	203 Count
1753177059	15 Count	193 Count
1753176158	14 Count	188 Count
1753175257	13 Count	145 Count
1753174357	12 Count	98 Count
1753173456	11 Count	89 Count
1753172555	10 Count	84 Count
1753171654	9 Count	77 Count
1753170754	8 Count	72 Count
1753169873	7 Count	63 Count
1753168972	6 Count	59 Count
1753168070	5 Count	48 Count
1753167169	4 Count	38 Count
1753166269	3 Count	28 Count
1753165368	2 Count	23 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)