EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

IZ2WZM-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IZ2WZM-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1757158795	66 Count	969 Count
1757157890	65 Count	951 Count
1757156985	64 Count	921 Count
1757156081	63 Count	899 Count
1757155176	62 Count	882 Count
1757154272	61 Count	864 Count
1757153367	60 Count	840 Count
1757152463	59 Count	827 Count
1757151558	57 Count	813 Count
1757150653	56 Count	797 Count
1757149748	55 Count	784 Count
1757148844	54 Count	774 Count
1757147939	53 Count	758 Count
1757147034	52 Count	744 Count
1757146130	51 Count	733 Count
1757145225	50 Count	718 Count
1757144321	49 Count	704 Count
1757143416	48 Count	684 Count
1757142512	47 Count	666 Count
1757141607	46 Count	651 Count
1757140703	45 Count	633 Count
1757139798	44 Count	617 Count
1757138893	43 Count	603 Count
1757137989	42 Count	591 Count
1757137084	41 Count	580 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)