EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP2PA-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2PA-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1764840082	483 Count	915 Count	157 Count
1764838281	482 Count	915 Count	157 Count
1764836480	481 Count	915 Count	157 Count
1764834679	480 Count	915 Count	157 Count
1764832878	479 Count	915 Count	157 Count
1764831077	478 Count	915 Count	157 Count
1764829275	477 Count	915 Count	157 Count
1764827474	476 Count	915 Count	157 Count
1764825686	475 Count	915 Count	157 Count
1764823885	473 Count	913 Count	156 Count
1764822084	472 Count	913 Count	156 Count
1764820282	471 Count	912 Count	156 Count
1764818481	469 Count	910 Count	155 Count
1764816681	468 Count	909 Count	155 Count
1764814879	466 Count	908 Count	154 Count
1764813078	465 Count	907 Count	154 Count
1764811277	463 Count	905 Count	153 Count
1764809476	461 Count	903 Count	152 Count
1764807675	459 Count	901 Count	151 Count
1764805874	457 Count	899 Count	150 Count
1764804084	455 Count	896 Count	149 Count
1764802283	454 Count	890 Count	149 Count
1764800481	453 Count	883 Count	149 Count
1764798681	452 Count	881 Count	149 Count
1764796880	450 Count	880 Count	148 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)