EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP1GDK-6 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP1GDK-6. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1757155067	449 Count	988 Count	335 Count
1757154208	438 Count	976 Count	328 Count
1757152405	427 Count	960 Count	318 Count
1757150602	413 Count	939 Count	305 Count
1757148800	403 Count	930 Count	296 Count
1757146996	391 Count	919 Count	285 Count
1757145193	382 Count	911 Count	277 Count
1757143391	370 Count	900 Count	266 Count
1757141587	362 Count	893 Count	259 Count
1757139786	352 Count	884 Count	250 Count
1757137982	345 Count	878 Count	244 Count
1757136179	334 Count	868 Count	234 Count
1757134376	327 Count	862 Count	228 Count
1757132606	312 Count	852 Count	218 Count
1757130803	303 Count	844 Count	210 Count
1757129000	292 Count	834 Count	200 Count
1757127198	282 Count	825 Count	191 Count
1757125395	270 Count	814 Count	180 Count
1757123595	260 Count	805 Count	171 Count
1757121789	249 Count	795 Count	161 Count
1757119986	239 Count	786 Count	152 Count
1757118184	227 Count	775 Count	141 Count
1757116381	217 Count	766 Count	132 Count
1757114578	205 Count	755 Count	121 Count
1757112775	196 Count	747 Count	113 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)