EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP1GDK-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP1GDK-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1757167593	187 Count	310 Count	147 Count
1757166988	183 Count	300 Count	144 Count
1757166387	178 Count	283 Count	140 Count
1757165784	173 Count	276 Count	136 Count
1757165180	169 Count	268 Count	133 Count
1757164577	165 Count	262 Count	130 Count
1757163973	160 Count	254 Count	126 Count
1757163370	157 Count	249 Count	124 Count
1757162767	151 Count	240 Count	119 Count
1757162164	147 Count	234 Count	116 Count
1757161561	142 Count	226 Count	112 Count
1757160958	139 Count	220 Count	110 Count
1757160355	133 Count	210 Count	105 Count
1757159753	130 Count	206 Count	103 Count
1757159153	125 Count	198 Count	99 Count
1757158546	120 Count	192 Count	95 Count
1757157943	115 Count	182 Count	91 Count
1757157340	112 Count	176 Count	89 Count
1757156738	105 Count	167 Count	83 Count
1757156135	102 Count	163 Count	81 Count
1757155532	97 Count	154 Count	77 Count
1757154929	93 Count	146 Count	74 Count
1757154327	87 Count	135 Count	69 Count
1757153723	83 Count	127 Count	66 Count
1757153120	78 Count	119 Count	62 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)