EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ2MO-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2MO-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1769959507	108 Count	533 Count	87 Count
1769958307	104 Count	502 Count	84 Count
1769957106	98 Count	470 Count	79 Count
1769955905	95 Count	440 Count	77 Count
1769954705	92 Count	420 Count	75 Count
1769953504	89 Count	390 Count	73 Count
1769952304	86 Count	369 Count	71 Count
1769951103	84 Count	349 Count	70 Count
1769949902	74 Count	300 Count	61 Count
1769948702	67 Count	266 Count	55 Count
1769947501	59 Count	234 Count	48 Count
1769946311	42 Count	191 Count	36 Count
1769945110	32 Count	159 Count	27 Count
1769943909	15 Count	110 Count	11 Count
1769942709	12 Count	83 Count	9 Count
1769941508	9 Count	62 Count	7 Count
1769940307	6 Count	42 Count	5 Count
1769939107	3 Count	22 Count	3 Count
1769937906	206 Count	1009 Count	157 Count
1769936706	203 Count	989 Count	155 Count
1769935505	200 Count	965 Count	153 Count
1769934304	197 Count	949 Count	151 Count
1769933103	193 Count	927 Count	148 Count
1769931903	190 Count	902 Count	146 Count
1769930702	186 Count	881 Count	143 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)