EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ2MO Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2MO. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1777819249	273 Count	874 Count	88 Count
1777818648	272 Count	872 Count	88 Count
1777818048	271 Count	869 Count	88 Count
1777817447	270 Count	866 Count	88 Count
1777816846	269 Count	862 Count	88 Count
1777816245	268 Count	861 Count	88 Count
1777815645	267 Count	858 Count	88 Count
1777815044	266 Count	857 Count	88 Count
1777814443	265 Count	854 Count	88 Count
1777813842	264 Count	851 Count	88 Count
1777813241	263 Count	849 Count	88 Count
1777812640	262 Count	848 Count	88 Count
1777812040	261 Count	845 Count	88 Count
1777811439	260 Count	843 Count	88 Count
1777810838	258 Count	835 Count	87 Count
1777810237	257 Count	831 Count	87 Count
1777809637	256 Count	829 Count	87 Count
1777809036	255 Count	827 Count	87 Count
1777808435	254 Count	823 Count	87 Count
1777807834	247 Count	814 Count	81 Count
1777807234	244 Count	801 Count	79 Count
1777806633	243 Count	777 Count	79 Count
1777806032	242 Count	774 Count	79 Count
1777805431	241 Count	771 Count	79 Count
1777804831	240 Count	757 Count	79 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)