EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

TA4HJ-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object TA4HJ-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1757341882	437 Count	418 Count	235 Count
1757340979	435 Count	417 Count	234 Count
1757340150	426 Count	401 Count	230 Count
1757339247	423 Count	384 Count	228 Count
1757338344	420 Count	379 Count	226 Count
1757337441	417 Count	362 Count	224 Count
1757336538	414 Count	360 Count	222 Count
1757335635	411 Count	357 Count	220 Count
1757334732	409 Count	356 Count	219 Count
1757333829	406 Count	353 Count	217 Count
1757332926	403 Count	350 Count	215 Count
1757332023	400 Count	347 Count	213 Count
1757331120	397 Count	344 Count	211 Count
1757330217	394 Count	341 Count	209 Count
1757329314	391 Count	338 Count	207 Count
1757328411	388 Count	335 Count	205 Count
1757327508	385 Count	332 Count	203 Count
1757326604	382 Count	329 Count	201 Count
1757325701	380 Count	328 Count	200 Count
1757324798	377 Count	325 Count	198 Count
1757323895	374 Count	322 Count	196 Count
1757322992	371 Count	320 Count	194 Count
1757322089	368 Count	317 Count	192 Count
1757320279	363 Count	314 Count	189 Count
1757319376	361 Count	313 Count	188 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)