EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

IU3ISP-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IU3ISP-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1773874277	70 Count	512 Count	40 Count
1773872473	69 Count	512 Count	40 Count
1773868866	67 Count	512 Count	40 Count
1773865258	64 Count	511 Count	39 Count
1773863498	59 Count	511 Count	39 Count
1773861694	57 Count	510 Count	38 Count
1773859890	55 Count	509 Count	37 Count
1773858086	53 Count	508 Count	36 Count
1773852674	41 Count	469 Count	27 Count
1773850870	38 Count	433 Count	25 Count
1773849067	33 Count	397 Count	21 Count
1773847263	30 Count	357 Count	19 Count
1773845459	26 Count	313 Count	16 Count
1773841895	14 Count	234 Count	10 Count
1773840091	11 Count	199 Count	8 Count
1773838288	8 Count	151 Count	6 Count
1773836483	5 Count	99 Count	4 Count
1773832875	107 Count	1042 Count	63 Count
1773831072	104 Count	996 Count	61 Count
1773829268	97 Count	950 Count	55 Count
1773827464	94 Count	905 Count	53 Count
1773825660	91 Count	860 Count	51 Count
1773823856	88 Count	817 Count	49 Count
1773822052	85 Count	771 Count	47 Count
1773818489	76 Count	711 Count	44 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)