EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ2WSZ-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2WSZ-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1777819924	63 Count	590 Count	18 Count
1777819023	62 Count	578 Count	18 Count
1777818123	61 Count	565 Count	18 Count
1777817222	60 Count	555 Count	18 Count
1777816321	59 Count	536 Count	18 Count
1777815420	58 Count	520 Count	18 Count
1777814520	57 Count	509 Count	18 Count
1777813619	56 Count	496 Count	18 Count
1777812718	55 Count	483 Count	18 Count
1777811818	54 Count	469 Count	18 Count
1777810917	51 Count	429 Count	16 Count
1777810016	50 Count	413 Count	16 Count
1777809115	49 Count	400 Count	16 Count
1777808232	44 Count	383 Count	16 Count
1777807331	42 Count	350 Count	15 Count
1777806430	26 Count	300 Count	0 Count
1777805529	25 Count	287 Count	0 Count
1777804628	24 Count	261 Count	0 Count
1777803728	23 Count	242 Count	0 Count
1777802827	22 Count	229 Count	0 Count
1777801926	21 Count	215 Count	0 Count
1777801026	20 Count	205 Count	0 Count
1777800124	19 Count	190 Count	0 Count
1777799223	18 Count	181 Count	0 Count
1777798323	17 Count	167 Count	0 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)