EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP8MB-L Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP8MB-L. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1761291751	811 Count	92 Count	92 Count
1761291630	810 Count	92 Count	92 Count
1761291510	809 Count	92 Count	92 Count
1761291389	808 Count	92 Count	92 Count
1761291268	807 Count	92 Count	92 Count
1761291147	805 Count	91 Count	91 Count
1761291026	804 Count	91 Count	91 Count
1761290905	803 Count	91 Count	91 Count
1761290785	802 Count	91 Count	91 Count
1761290664	801 Count	91 Count	91 Count
1761290542	800 Count	91 Count	91 Count
1761290421	799 Count	91 Count	91 Count
1761290300	797 Count	90 Count	90 Count
1761290179	796 Count	90 Count	90 Count
1761290059	795 Count	90 Count	90 Count
1761289938	794 Count	90 Count	90 Count
1761289817	793 Count	90 Count	90 Count
1761289696	792 Count	90 Count	90 Count
1761289575	791 Count	90 Count	90 Count
1761289454	790 Count	90 Count	90 Count
1761289333	788 Count	89 Count	89 Count
1761289212	787 Count	89 Count	89 Count
1761289092	786 Count	89 Count	89 Count
1761288971	785 Count	89 Count	89 Count
1761288850	784 Count	89 Count	89 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)