EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SO9G-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SO9G-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1777804012	128 Count	658 Count	105 Count
1777802211	124 Count	634 Count	102 Count
1777800411	119 Count	608 Count	98 Count
1777798610	116 Count	595 Count	96 Count
1777796810	110 Count	572 Count	91 Count
1777795009	106 Count	549 Count	88 Count
1777793208	100 Count	527 Count	83 Count
1777791408	96 Count	509 Count	80 Count
1777789607	88 Count	488 Count	73 Count
1777787807	84 Count	474 Count	70 Count
1777786006	78 Count	446 Count	65 Count
1777784207	71 Count	409 Count	59 Count
1777782407	65 Count	374 Count	54 Count
1777780606	59 Count	337 Count	49 Count
1777778805	53 Count	300 Count	44 Count
1777777005	47 Count	272 Count	39 Count
1777775204	41 Count	240 Count	34 Count
1777773403	35 Count	208 Count	29 Count
1777771603	28 Count	172 Count	23 Count
1777769802	23 Count	142 Count	19 Count
1777768001	17 Count	111 Count	14 Count
1777766201	11 Count	79 Count	9 Count
1777764400	6 Count	47 Count	5 Count
1777762608	4 Count	27 Count	4 Count
1777760807	143 Count	1011 Count	109 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)