EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP2SGK-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2SGK-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1769970504	68 Count	62 Count	35 Count
1769969601	66 Count	60 Count	34 Count
1769968698	64 Count	59 Count	33 Count
1769967795	62 Count	57 Count	32 Count
1769966892	60 Count	55 Count	31 Count
1769965989	58 Count	53 Count	30 Count
1769965086	56 Count	52 Count	29 Count
1769964183	54 Count	51 Count	28 Count
1769963280	52 Count	49 Count	27 Count
1769962449	50 Count	47 Count	26 Count
1769961546	48 Count	45 Count	25 Count
1769960643	46 Count	43 Count	24 Count
1769959740	44 Count	41 Count	23 Count
1769958837	42 Count	40 Count	22 Count
1769957934	40 Count	38 Count	21 Count
1769957031	38 Count	36 Count	20 Count
1769956128	36 Count	34 Count	19 Count
1769955225	34 Count	32 Count	18 Count
1769954322	32 Count	30 Count	17 Count
1769953419	30 Count	28 Count	16 Count
1769952516	28 Count	26 Count	15 Count
1769951613	26 Count	24 Count	14 Count
1769950710	24 Count	23 Count	13 Count
1769949807	22 Count	21 Count	12 Count
1769948904	20 Count	19 Count	11 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)