EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP9KKK-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9KKK-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1777803135	12 Count	338 Count
1777802234	11 Count	305 Count
1777801333	6 Count	218 Count
1777800431	4 Count	123 Count
1777799531	0 Count	24 Count
1777798630	39 Count	1058 Count
1777797729	34 Count	985 Count
1777796828	33 Count	926 Count
1777795927	27 Count	832 Count
1777795026	26 Count	801 Count
1777794125	21 Count	723 Count
1777793224	20 Count	672 Count
1777792323	16 Count	524 Count
1777791422	15 Count	497 Count
1777790522	10 Count	343 Count
1777789621	9 Count	230 Count
1777788720	5 Count	150 Count
1777787819	4 Count	90 Count
1777786918	28 Count	1080 Count
1777786017	27 Count	978 Count
1777785116	23 Count	850 Count
1777784215	22 Count	761 Count
1777783315	17 Count	644 Count
1777782414	16 Count	595 Count
1777781512	12 Count	463 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)