EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SV1SSF-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SV1SSF-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1773890725	318 Count	617 Count	212 Count
1773889820	315 Count	614 Count	210 Count
1773888915	309 Count	605 Count	205 Count
1773888010	305 Count	600 Count	202 Count
1773887105	304 Count	598 Count	202 Count
1773886200	301 Count	592 Count	200 Count
1773885296	299 Count	589 Count	199 Count
1773884390	298 Count	585 Count	199 Count
1773883485	293 Count	575 Count	195 Count
1773882580	287 Count	567 Count	190 Count
1773881675	279 Count	558 Count	183 Count
1773880770	274 Count	549 Count	179 Count
1773879865	272 Count	546 Count	178 Count
1773878960	269 Count	541 Count	176 Count
1773878055	266 Count	536 Count	174 Count
1773877150	262 Count	531 Count	171 Count
1773876245	261 Count	529 Count	171 Count
1773875340	260 Count	528 Count	171 Count
1773874436	257 Count	523 Count	169 Count
1773873531	256 Count	523 Count	169 Count
1773872626	251 Count	514 Count	165 Count
1773871721	249 Count	513 Count	164 Count
1773870816	248 Count	511 Count	164 Count
1773869911	247 Count	509 Count	164 Count
1773869006	244 Count	504 Count	162 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)