EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

F6ZBY-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F6ZBY-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1777781803	315 Count	57 Count
1777780003	314 Count	57 Count
1777778202	313 Count	57 Count
1777776401	312 Count	56 Count
1777774601	311 Count	56 Count
1777771012	309 Count	55 Count
1777769212	308 Count	55 Count
1777767411	307 Count	55 Count
1777765610	306 Count	55 Count
1777763810	305 Count	54 Count
1777762009	304 Count	53 Count
1777760208	303 Count	53 Count
1777758408	302 Count	53 Count
1777756607	301 Count	52 Count
1777754806	300 Count	51 Count
1777753006	299 Count	51 Count
1777751205	298 Count	50 Count
1777749407	297 Count	50 Count
1777747607	296 Count	49 Count
1777745806	295 Count	49 Count
1777744005	294 Count	49 Count
1777742204	293 Count	49 Count
1777740404	292 Count	49 Count
1777738603	291 Count	49 Count
1777736802	290 Count	48 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)