EA2RCF LoRa APRS MAP

My position About Powered by EA2RCF Radioclub Foronda ☰

reset

E70ARA-14 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object E70ARA-14. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*
1749241157	439	33
1749240257	433	39
1749239357	429	33
1749238457	433	33
1749237565	423	33
1749236665	424	33
1749235765	431	33
1749234857	427	33
1749233957	438	35
1749233057	431	33
1749232157	434	33
1749231256	433	33
1749230357	435	33
1749229456	425	37
1749228556	426	33
1749227656	434	33
1749226756	435	33
1749225856	434	33
1749224956	425	38
1749224056	424	33
1749223156	425	33
1749222256	431	33
1749221354	421	33
1749220457	426	33
1749219557	423	33

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)