EA2RCF LoRa APRS MAP

My position About Powered by EA2RCF Radioclub Foronda ☰

reset

SQ5STR-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ5STR-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1745022067	32 Count	301 Count
1745021167	31 Count	291 Count
1745020266	30 Count	283 Count
1745019366	29 Count	273 Count
1745018465	28 Count	265 Count
1745017564	27 Count	258 Count
1745016664	26 Count	252 Count
1745015763	25 Count	243 Count
1745014862	24 Count	238 Count
1745013962	23 Count	231 Count
1745013061	22 Count	227 Count
1745012160	21 Count	218 Count
1745011260	20 Count	208 Count
1745010359	19 Count	198 Count
1745009458	18 Count	191 Count
1745008557	17 Count	182 Count
1745007657	16 Count	174 Count
1745007120	15 Count	174 Count
1745006219	14 Count	167 Count
1745005319	13 Count	157 Count
1745005122	12 Count	153 Count
1745004222	11 Count	146 Count
1745003321	10 Count	136 Count
1745002420	9 Count	128 Count
1745001519	8 Count	101 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)