EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

PD2ATG-5 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object PD2ATG-5. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	RX*	Digi*
1761162240	494 Count	102 Count
1761160445	486 Count	100 Count
1761158645	475 Count	98 Count
1761156845	465 Count	96 Count
1761155045	454 Count	95 Count
1761153245	445 Count	93 Count
1761151445	432 Count	92 Count
1761149644	426 Count	90 Count
1761147844	412 Count	88 Count
1761146044	405 Count	86 Count
1761144244	394 Count	84 Count
1761142444	389 Count	83 Count
1761140644	384 Count	82 Count
1761138845	379 Count	81 Count
1761137045	371 Count	80 Count
1761135245	363 Count	78 Count
1761133445	353 Count	76 Count
1761131644	346 Count	74 Count
1761129844	338 Count	72 Count
1761128044	333 Count	71 Count
1761126244	323 Count	69 Count
1761124443	318 Count	67 Count
1761122643	310 Count	65 Count
1761120843	305 Count	63 Count
1761119043	295 Count	61 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)