EA2RCF LoRa APRS MAP

My position About Powered by EA2RCF Radioclub Foronda ☰

reset

SP1KRF-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP1KRF-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1747170958	261 Count	413 Count	107 Count
1747169756	258 Count	408 Count	106 Count
1747168555	254 Count	402 Count	104 Count
1747167353	251 Count	397 Count	103 Count
1747166152	246 Count	390 Count	100 Count
1747164950	243 Count	385 Count	99 Count
1747163749	239 Count	379 Count	97 Count
1747162547	236 Count	374 Count	96 Count
1747160146	229 Count	363 Count	93 Count
1747158966	226 Count	358 Count	92 Count
1747157764	223 Count	353 Count	91 Count
1747156563	219 Count	347 Count	89 Count
1747155362	216 Count	342 Count	88 Count
1747154160	212 Count	336 Count	86 Count
1747152959	208 Count	330 Count	84 Count
1747151757	205 Count	325 Count	83 Count
1747150556	202 Count	320 Count	82 Count
1747149354	198 Count	314 Count	80 Count
1747148153	195 Count	309 Count	79 Count
1747146951	192 Count	304 Count	78 Count
1747145750	188 Count	298 Count	76 Count
1747144548	185 Count	293 Count	75 Count
1747143347	180 Count	286 Count	72 Count
1747142146	177 Count	281 Count	71 Count
1747140944	174 Count	276 Count	70 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)