EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ8RZE-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ8RZE-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1773895269	2 Count	27 Count	2 Count
1773894368	206 Count	1011 Count	173 Count
1773893468	204 Count	992 Count	172 Count
1773892567	197 Count	960 Count	166 Count
1773891666	194 Count	927 Count	164 Count
1773890766	191 Count	900 Count	162 Count
1773889865	189 Count	871 Count	161 Count
1773888964	182 Count	842 Count	155 Count
1773888063	179 Count	815 Count	153 Count
1773887163	176 Count	790 Count	151 Count
1773886262	174 Count	756 Count	150 Count
1773885377	163 Count	722 Count	144 Count
1773884476	160 Count	695 Count	142 Count
1773883576	157 Count	668 Count	140 Count
1773882675	155 Count	646 Count	139 Count
1773881774	148 Count	620 Count	133 Count
1773880874	145 Count	592 Count	131 Count
1773879973	142 Count	567 Count	129 Count
1773879072	131 Count	538 Count	119 Count
1773878173	123 Count	508 Count	112 Count
1773877271	120 Count	479 Count	110 Count
1773876370	117 Count	449 Count	108 Count
1773875469	115 Count	418 Count	107 Count
1773874569	101 Count	372 Count	94 Count
1773873668	87 Count	307 Count	81 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)