EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

F4IZM-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F4IZM-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1777786947	2 Count	13 Count	2 Count
1777785142	184 Count	1004 Count	128 Count
1777783337	181 Count	991 Count	126 Count
1777781533	178 Count	977 Count	124 Count
1777779727	175 Count	961 Count	122 Count
1777777922	172 Count	939 Count	120 Count
1777776117	169 Count	915 Count	118 Count
1777774313	166 Count	886 Count	116 Count
1777772508	163 Count	858 Count	114 Count
1777770703	160 Count	834 Count	112 Count
1777768898	157 Count	802 Count	110 Count
1777767093	154 Count	770 Count	108 Count
1777765288	151 Count	754 Count	106 Count
1777763483	148 Count	740 Count	104 Count
1777761679	145 Count	724 Count	102 Count
1777759874	142 Count	696 Count	100 Count
1777758069	139 Count	660 Count	98 Count
1777756264	136 Count	630 Count	96 Count
1777754459	133 Count	615 Count	94 Count
1777752654	130 Count	601 Count	92 Count
1777750849	127 Count	589 Count	90 Count
1777749045	124 Count	577 Count	88 Count
1777747240	121 Count	566 Count	86 Count
1777745435	118 Count	555 Count	84 Count
1777743630	115 Count	544 Count	82 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)