EA2RCF LoRa APRS MAP

My position About Powered by EA2RCF Radioclub Foronda ☰

reset

SP9DAT-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9DAT-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1749241925	725 Count	848 Count	427 Count
1749241024	712 Count	827 Count	415 Count
1749240123	701 Count	807 Count	405 Count
1749239223	698 Count	801 Count	403 Count
1749238321	695 Count	796 Count	401 Count
1749237421	691 Count	791 Count	398 Count
1749227597	662 Count	777 Count	384 Count
1749222191	639 Count	760 Count	367 Count
1749220389	634 Count	757 Count	364 Count
1749219488	629 Count	753 Count	360 Count
1749218587	613 Count	738 Count	345 Count
1749217686	611 Count	737 Count	344 Count
1749216785	609 Count	736 Count	343 Count
1749215884	608 Count	736 Count	343 Count
1749214984	606 Count	735 Count	342 Count
1749214083	604 Count	734 Count	341 Count
1749213182	602 Count	733 Count	340 Count
1749212281	600 Count	732 Count	339 Count
1749211380	599 Count	732 Count	339 Count
1749206876	591 Count	729 Count	336 Count
1749205975	589 Count	728 Count	335 Count
1749205074	588 Count	728 Count	335 Count
1749204173	586 Count	727 Count	334 Count
1749201470	581 Count	724 Count	332 Count
1749200569	579 Count	723 Count	331 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)