EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ9PD-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9PD-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1769959863	26 Count	162 Count	11 Count
1769958962	23 Count	147 Count	9 Count
1769958061	21 Count	135 Count	8 Count
1769957161	19 Count	125 Count	7 Count
1769956278	14 Count	118 Count	7 Count
1769955377	13 Count	110 Count	7 Count
1769954476	12 Count	100 Count	7 Count
1769953576	10 Count	86 Count	6 Count
1769952675	8 Count	73 Count	5 Count
1769951774	6 Count	61 Count	4 Count
1769950874	5 Count	50 Count	4 Count
1769949973	0 Count	14 Count	0 Count
1769949072	104 Count	1011 Count	66 Count
1769948172	100 Count	973 Count	63 Count
1769947271	98 Count	929 Count	62 Count
1769946370	92 Count	876 Count	57 Count
1769945470	87 Count	835 Count	53 Count
1769944569	86 Count	823 Count	53 Count
1769943668	85 Count	806 Count	53 Count
1769942768	83 Count	785 Count	52 Count
1769941867	79 Count	738 Count	49 Count
1769940966	77 Count	725 Count	48 Count
1769940066	76 Count	697 Count	48 Count
1769939165	71 Count	596 Count	44 Count
1769938264	70 Count	573 Count	44 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)