EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP2ROC-14 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2ROC-14. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1777811720	199 Count	439 Count	139 Count
1777811299	196 Count	436 Count	137 Count
1777810878	194 Count	432 Count	136 Count
1777810458	189 Count	424 Count	132 Count
1777810037	188 Count	420 Count	132 Count
1777809616	184 Count	410 Count	129 Count
1777809196	182 Count	404 Count	128 Count
1777808775	179 Count	399 Count	126 Count
1777808353	176 Count	390 Count	124 Count
1777807932	173 Count	384 Count	122 Count
1777807091	168 Count	369 Count	119 Count
1777806671	161 Count	354 Count	114 Count
1777806521	156 Count	350 Count	113 Count
1777805259	142 Count	321 Count	102 Count
1777804838	137 Count	311 Count	98 Count
1777804418	135 Count	304 Count	97 Count
1777803997	132 Count	299 Count	95 Count
1777803577	130 Count	293 Count	94 Count
1777803156	121 Count	278 Count	86 Count
1777802736	119 Count	269 Count	85 Count
1777802315	114 Count	263 Count	81 Count
1777801895	112 Count	258 Count	80 Count
1777801474	106 Count	245 Count	75 Count
1777801053	105 Count	243 Count	75 Count
1777800633	100 Count	232 Count	71 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)