EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP9APJ-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9APJ-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1773877083	221 Count	983 Count	190 Count
1773875282	213 Count	939 Count	183 Count
1773873481	206 Count	897 Count	177 Count
1773871681	198 Count	852 Count	170 Count
1773869880	192 Count	812 Count	165 Count
1773868079	180 Count	768 Count	154 Count
1773862678	146 Count	627 Count	123 Count
1773860877	137 Count	589 Count	115 Count
1773857282	120 Count	525 Count	104 Count
1773855481	114 Count	494 Count	99 Count
1773853680	109 Count	459 Count	95 Count
1773851880	102 Count	422 Count	89 Count
1773850079	88 Count	364 Count	76 Count
1773848278	81 Count	331 Count	70 Count
1773844677	40 Count	212 Count	31 Count
1773842877	33 Count	181 Count	25 Count
1773841076	24 Count	124 Count	17 Count
1773839276	20 Count	83 Count	14 Count
1773837475	15 Count	51 Count	10 Count
1773835681	6 Count	32 Count	6 Count
1773833880	209 Count	1024 Count	175 Count
1773832079	204 Count	995 Count	171 Count
1773830278	200 Count	966 Count	168 Count
1773828478	196 Count	937 Count	165 Count
1773826677	191 Count	906 Count	161 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)